Cisco IOS and IOS-XE Upgrade Guide: Catalyst Switches and ISR Routers

Most Cisco upgrades fail before the first command is typed: the wrong image for the platform, too little space in flash, a ROMMON that is too old for the target release, or a boot variable that points nowhere. This guide puts the checks first and the commands second. It covers both families you meet in practice: Family Typical models Software File system Upgrade method Classic Catalyst switches 2960, 2960-X, 3560, 3750 IOS flash: archive download-sw or .bin + boot system IOS-XE Catalyst switches 3650, 3850, 9200, 9300, 9400, 9500 IOS-XE flash: (on some models bootflash:) Install mode (packages.conf) IOS-XE routers ISR 4000, ISR 1100, Catalyst 8200/8300, Catalyst 8000V IOS-XE bootflash: Install mode or bundle mode Classic IOS routers ISR G2, C900 IOS flash: .bin + boot system The commands are the ones I use in the field on Catalyst switches and ISR routers. IP addresses and paths in the examples are placeholders. ...

October 22, 2026 · 7 min · Barash Helvadzhaoglu

Cisco ROMMON Recovery: Boot a Switch or Router from Flash, TFTP or USB

After a reload, the device does not come back. On the console you see only switch: (Catalyst switches) or rommon 1 > (routers). This is ROMMON, also called the boot loader: the small program that starts IOS. It stopped because it could not find or start a valid image. This is not a hardware failure in most cases, and you do not need to replace the device. Which way out you take depends on one question: is a good image still in flash? ...

October 22, 2026 · 7 min · Barash Helvadzhaoglu