Cisco IOS and IOS-XE Upgrade Guide: Catalyst Switches and ISR Routers

Most Cisco upgrades fail before the first command is typed: the wrong image for the platform, too little space in flash, a ROMMON that is too old for the target release, or a boot variable that points nowhere. This guide puts the checks first and the commands second. It covers both families you meet in practice: Family Typical models Software File system Upgrade method Classic Catalyst switches 2960, 2960-X, 3560, 3750 IOS flash: archive download-sw or .bin + boot system IOS-XE Catalyst switches 3650, 3850, 9200, 9300, 9400, 9500 IOS-XE flash: (on some models bootflash:) Install mode (packages.conf) IOS-XE routers ISR 4000, ISR 1100, Catalyst 8200/8300, Catalyst 8000V IOS-XE bootflash: Install mode or bundle mode Classic IOS routers ISR G2, C900 IOS flash: .bin + boot system The commands are the ones I use in the field on Catalyst switches and ISR routers. IP addresses and paths in the examples are placeholders. ...

October 22, 2026 · 7 min · Barash Helvadzhaoglu

Cisco ROMMON Recovery: Boot a Switch or Router from Flash, TFTP or USB

After a reload, the device does not come back. On the console you see only switch: (Catalyst switches) or rommon 1 > (routers). This is ROMMON, also called the boot loader: the small program that starts IOS. It stopped because it could not find or start a valid image. This is not a hardware failure in most cases, and you do not need to replace the device. Which way out you take depends on one question: is a good image still in flash? ...

October 22, 2026 · 7 min · Barash Helvadzhaoglu

Cisco Switch and Router Password Recovery: Catalyst 9000, 2960, 3560 and ISR

You inherit a device without documentation, or a lab switch comes back from storage and asks for a password nobody knows. On Cisco switches and routers you can recover from this without losing the configuration, as long as you have physical access and a console cable. The principle is the same everywhere: interrupt the boot, start IOS without loading the startup configuration, then put the configuration back and set new passwords. Only the way you tell the device to skip the configuration differs: ...

October 22, 2026 · 5 min · Barash Helvadzhaoglu

TFTP, FTP and SCP Servers for Cisco Upgrades: Setup and Troubleshooting

Every Cisco upgrade starts with getting a file onto the device. For a 20 MB classic IOS image, almost anything works. For a 1 GB IOS-XE image over a WAN link, the choice of protocol decides whether the copy takes five minutes or fails after an hour. This guide covers which protocol to use, how to set up the server on Windows, macOS and Linux, and the device-side commands and pitfalls. ...

October 22, 2026 · 5 min · Barash Helvadzhaoglu